Zigbee actuator 230V - the simple control of high-voltage lamps via light switch

Even your already active LED lamps and luminaires can be operated smart and coordinated at 230V. This does not require a connection of power supply and controller but only the appropriate component. Our high voltage Zigbee actuator brings everything necessary and is perfect for switching on and off at 230V. Dimming is not possible via light switch, but in combination with the Philips Hue Bridge or our Zigbee hand-held remote control.

If your lights also meet the following requirements, nothing stands in the way of a successful cooperation: they are dimmable per phase section at 230V constant voltage and can be dimmed with pulse width modulation (PWM).

If the mentioned requirements are fulfilled, our radio actuator is suitable for 

• LED lamps

• LED lamps incl. driver

• Halogen lamps (GU10)

• Incandescent bulbs

Compatible Zigbee coordinators 

Our actuator communicates via Zigbee and thus addresses many coordinators such as Philips Hue. Pairing with the Philips Hue Bridge gives you a comprehensive and orderly integration of many LED lamps. With the Philips Hue Bridge, HomeKit is also supported, but not entertainment. But these gateways are also compatible with our Zigbee actuator:

• Amazon Echo Dot Gen. 4

• IKEA TRÅDFRI

• Google Assistant

• and many more 

Also for changeover circuit 

Unlike its predecessor 5120.1, our newcomer scores with the important advantage of changeover switching (cross switching). This enables the operation of several light switches within one circuit and with only one actuator. This compatible interaction is ideal for corridor lighting or in stairwells. The voltage range here (for switching) is 8-230V, so that just about any light switch can be used.

Coordinated operation

Choose between different Zigbee Touchlink capable controllers and take control of your white lights into your own hands. Whether  remote control, wall dimmer or via smartphone? With just a few smart clicks, you can control the light in your four walls.

Effective setting

At the touch of a button, you can set the minimum brightness to prevent the connected lamps from flickering. This phenomenon occurs when your lamps are dimmed too much. 

With and without N-conductor

Works with and without N-wire - without N-wire please use the iluminize  Bypass according to the wiring diagram if the LED is less than 20W or if the lamps are afterglowing. This is also available in our compatible  Bypass-Set. Operation without neutral conductor is only possible with the marked models.

Simple mounting

Thanks to its small size and compactness, our Zigbee actuator can find a place in many locations. In case of deep flush-mounted boxes (min. 60mm deep) it is also possible to mount a switch or a socket above the actuator. Please note the necessary safety regulations.

Scope of delivery

The device is delivered without remote control and coordinator and requires additional components for operation. You can also find them in our store under the category  Zigbee . With the delivery you get:

• 1 x Zigbee actuator

• 1 x Mounting instruction

Important to know

• Zigbee Lightlink & Touchlink (3.0)

• LED max. 200W / Halogen max. 400W

• If the actuator is disconnected from the mains or the power fails, it "remembers" the last setting.

• LED filament lamps can often only be dimmed strongly by accepting flicker

• Pushbuttons with status lights must not be used

• Drivers & LED lamps can sometimes only be dimmed to 50/60% flicker-free, depending on the type. This is due to technical restrictions on the respective driver and is not caused by this actuator.